Filter
Top Products
TL-R4299G Dual-WAN SMB Broadband Router User Guide
43
Step 2: Click Add New…/Modify shown in Figure 4-31, you will see a new screen shown in
Figure 4-32.
Step 3: Enter the “Effective time” that the rule
will take effect as shown in Figure 4-32.
Step 4: Enter the “L
AN IP Address”, “LAN Port”, “WAN IP Address” and “WAN Port” in the
corresponding field as shown in Figure 4-32.
Step 5: Select the “Protocol”, “Action” and “Status” for the rule as shown in the next screen.
Figure 4-32
Step 6: Click the Save button to save this entry.
Step 7: Go to Step 2 to complete the other rules continually.
After you finish the configurations, you will see the rules in the table below:
Figure 4-33
)
Note:
Before adding an IP Address Filtering entry, you should enable the Firewall and the IP Address
Filtering function first (shown in Figure 4-30).
Other configurations for the entries
as shown in Figure 4-31:
Click the Delete button to delete the entry.
Click the Enable All button to enable all the entries.
Click the Disable All button to disable all the entries.
Click the Delete All button to delete all the entries.
Click the Previous button to view the information in the previous screen, click the Next button to
view the information in the next screen.