Filter
Top Products
Note:
-If there is no heart rate signal for 2 minutes, the heart rate reception will be disabled and the
heart rate icon will be turned off.
-When the user saves or clears the chronograph record on chronograph mode, the maximum,
average and minimum heart rate record are saved and cleared at the same time.
-If heart rate signal is lost, the last heart rate value will remain on display for around 8 more
seconds before the screen will show"--". The watch will continue to try to detect the signal for
2 more minutes before logging out.
-If the heart rate belt is on low batteries, the watch will display the low battery icon.
-When chronograph has been activated, training mode cannot be activated at the same time or
vice versa.
Training Mode:
1. Press the MODE/SET key until you have reached a screen
entitled training
2. It should show current heart rate and target distance and to switch to training 2, press and
hold the EL/RESET button for around 3 seconds and repeat this to access training 3 and 4
or back to 1 again
3. The default training screen should show speed, current heart rate,
training 1 and distance
4. The user can toggle through different data combinations by pressing LAP/SAVE/ - button to
average heart rate, training 1 and remaining distance and a combination of calorie, maximum
heart rate, training 1 and fat burnt before returning to first cycle
5. To start training, press the ST/SP/+ button and first speed
reading will show after approximately 6 seconds. To stop
or pause training, press ST/SP/+ button again.
9