Filter
Top Products
10
6. To save data, press and hold the LAP/SAVE/-
button for around 3 seconds and to select
whether to save or erase data use the
ST/SP/+ button. And to hold the LAP/SAVE/-
key for around 3 seconds to confirm your
decision.
Note:
-If there is no heart rate signal for 2 minutes, the heart rate reception will be disabled and the
heart rate icon will be turned off.
-When the user saves or clears the chronograph record on chronograph mode, the maximum,
average and minimum heart rate record are saved and cleared at the same time.
-If heart rate signal is lost, the last heart rate value will remain on display for around 8 more
seconds before the screen will show"---". The watch will continue to try to detect the signal for 2
more minutes before logging out.
-If the heart rate belt is on low batteries, the watch will display the low battery icon.
-When chronograph has been activated, training mode cannot be activated at the same time or
vice versa
Training Setting Mode:
Training time with Current Heart Rate and Target distance
1. Press the MODE/SET key until you have reached a screen
entitled training
2. Press and hold the MODE/SET key until training 1 banner starts flashing and select training 1
or 2 by pressing LAP/SAVE/ - or ST/SP/+ button
Confirm choice by pressing MODE/SET key and adjust distance by press the ST/SP/+ button
and to increment distance, press the LAP/SAVE/ - button to decrement distance
3. Press MODE/SET key to confirm
4. To exit the setting mode, press and hold the MODE/SET
key for around 3 seconds or wait for one minute when it will
automatically exit the mode itself but previous settings will
remain unchanged
Note:
- It can only enter training setting mode if training is stopped.
- It can only enter training setting mode when data in training record is cleared.
- When quitting the training setting mode, it will return back to previous display before entering the
training mode.