PYLE Audio PHRM20 Heart Rate Monitor User Manual


 
NOTE
- When you walk or run for around 10 seconds, the unit sensor will pick this up and a display
showing current pace for the walk or run will appear.
- If you wish to have the most accurate fitness index calculated by the unit, the user must
use the calibration feature for both walking and running. They will also need to input their
personal user settings
- Your watch is designed to count your steps when it is worn on your left hand. It will not count
your steps correctly if you wear it on your right wrist or on your belt, or if you have it in your
bag.
In order to maximize the accuracy of the step counting feature of the
watch, please wear the watch properly as shown in the diagram
(strap of the watch must fasten tightly around the wrist and it must
not be loose; display must also be perpendicular to the forearm and
wrist; the watch must only be worn on the left wrist and not the right
to maximize the accuracy of step counting) The design and accuracy
of the watch for step counting is based on the positioning of the watch.
The 3D sensor of the watch will automatically count the steps. By
wearing the watch correctly, the steps counted during the daily walk
and, or run will be more accurate.
Please take off the strap from your wrist before you take out the watch
unit.
4
Low battery detection
Chime
LAP Lap No.
ZONE Heart rate zone select 1/2/3
Kmi/h Kilometer or mile per hour
Heart rate detection
MAX Maximum
Avg Average
Min Minimum
Memory record
/min Heart beat per minute
Alarm 1 or 2
CAL Calories alert on
9FAT Unit of fat burnt
Kcal Unit of calories burnt
Step Step you have walk
AM Time from 0:00.00 to 11:59.59
PM Time from 12:00.00 to 23:59.59
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
USING THE USB CONNECTOR
- When sliding the USB connector in and out from beneathe the watch,
please press and slide the USB connector where there is the thumb
slide pivot. Please take care and do not push the USB connector back into place when it is
locked in its extended position otherwise this will permanently damage the USB connector.
1
Press Down
2 Slide Out
1
Press Down
2 Slide Back