Filter
Top Products
Note:
1. Press and holding the MODE/SET key will quit the mode immediately and go back to Lap/
Training Record Selection Mode.
2. In Memory recall mode, if there is no key press or key hold for 60s, it will return to Clock mode.
3. In Chronograph memory recall mode, if there is an error on reading the data, then an error
display is shown:
Training Memory Recall
1. Press MODE/SET key to enter memory data
where the screen showing RECALL with
Training will appear after approximately 2
seconds
2. To increment the data record, press the ST/SP/+ button and to
decrement the data record, press the LAP/SAVE/ - button
3. Press and hold the MODE/SET button for around 3 seconds to enter the
data record and press the ST/SP/+ button to scroll through the data stored
12
6. Hold the EL/RESET key for around 3 seconds to delete and toggle all yes , or no by pressing
the LAP/SAVE/ - or ST/SP/+ button
7. Press MODE/SET key to confirm