PYLE Audio PHRM20 Heart Rate Monitor User Manual


 
3D SENSOR FROM GERMANY-MEASURES YOUR MOVEMENT ACCURATELY
-The 3D technology in the accelerator is an accelerometer Sensor to measure acceleration in
walking or running.
-3D Sensor has intelligent step filter function-steps only count when the unit detects
-3D Sensor allows users to customize to their specific body type for Walking/Running style
The Complete Training System
Thank you for choosing Pulse Sonic The Complete Training System as your personal trainer. In
order to be able to make the best use of this device, please read the instruction manual carefully.
Do not discard keep the manual for future reference.
Wear the Heart Rate Belt on your chest with the sensor over your heart for detection of the heart
rate.
You will notice that there are two noticeably different patches on the inside of the
Heart Rate Belt These are the sensor for detecting your Heart Rate. Before you wear the Heart
Rate Belt, wet these two patches lightly so that the sensor can detect your heart rate more easily.
faster and with increased accuracy.
Important: Please note that the Heart Rate Monitor is NOT a medical device and is not to be used
as such.
TIPS:
The position of the chest belt affects its performance .Move the chest belt along strap so that it
falls above your heart.
Avoid areas with dense chest hair.
In dry, cold climates ,it may take several minutes for the chest belt to function steadily.
This is normal and should improve with several minutes of exercise.
The chest belt is splash proof and should not be worn for underwater activities.
WARNING: Signal interference can be caused in the
environment due to electromagnetic disturbances. These
may occur near high voltage power lines, traffic lights ,
overhead lines of electric railways, electric bus lines or
trams ,televisions ,computers,car motor, bike computer ,
some motor driven exercise equipment ,cellular phones
or when you walk through electric security gates.
The USB connector must not come in contact with the
water as this will oxidize the metal contact points and
will damage the connection between the USB and the
computer.
2