Filter
Top Products
7
133
58
137
67
58
123
67
5. Identify the Incline Axle (137), which is the longest
remaining axle. Slide an M6 Washer (58) onto an M6 x
18mm Button Screw (67). Tighten the Button Screw into
one end of the Incline Axle. Apply a small amount of
grease to the Incline Axle.
Raise the Ramp (133). Insert the Incline Axle (137) into
one side of the Ramp, through an Incline Spacer (123),
through the motor screw, through the other Incline
Spacer, and then into the other side of the Ramp.
As
you insert the Incline Axle through the motor screw,
make sure that the motor screw does not turn.
Slide an M6 Washer (58) onto an M6 x 18mm Button
Screw (67). Tighten the Button Screw into the other end
of the Incline Axle (137).
Motor Screw
4
133
67
67
132
132
128
130
130
Tube
1
4. Identify the Ramp Axle (128), which is the longest axle.
Slide a Ramp Axle Cover (132) onto an M6 x 18mm
B
utton Screw (67) as shown. Tighten the Button Screw
into one end of the Ramp Axle. Apply a small amount of
t
he included grease to the Ramp Axle.
Have a second person hold the two Ramp Spacers
(130) against the sides of the Frame (1) so they cover
the indicated tubes on the Frame. See the inset draw-
ing. Make sure that the Ramp Spacers are oriented
as shown. Next, lift the Flex Bars (not shown) out of
the way and align the round tubes on the Ramp (133)
with the Ramp Spacers.
Make sure that the Ramp is
turned as shown. Insert the Ramp Axle (128) into the
Ramp, the Ramp Spacers, and the Frame. Note: It may
be helpful to use a rubber mallet.
Slide the other Ramp Cover (132) onto an M6 x 18mm
Button Screw (67) as shown. Tighten the Button Screw
into the other end of the Ramp Axle (128).
Grease
Grease
5
130
Side View
Wide
End
Up