Filter
Top Products
21
THE OPTIONAL CHEST PULSE SENSOR
T
he optional chest pulse sensor provides hands-free
operation and continuously monitors your heart rate
d
uring your workouts.
T
o purchase the optional
chest pulse sensor, call the toll-free telephone
number on the front cover of this manual.
If you have purchased the optional chest pulse
sensor, follow the steps below to install the receiv-
er included with the chest pulse sensor.
1. Look under the housing (A) and locate the two
recessed screws (B). Remove the two screws, and
remove the cover (C) from the housing. Set the
cover and the screws aside.
2. Gently remove the housing (A) from the Upright (2)
and the Water Bottle Holder (91).
3. See the inset drawing. Wrap the wires (D) on the
r
eceiver (E) lengthwise around the receiver as
shown.
Make sure that the wires and the con-
nector are not touching the small cylinder.
4. Hold the receiver (E) so the small cylinder is orient-
ed as shown, and carefully insert the receiver into
the housing (A). Attach the receiver to the housing
with the two screws (F) included with the chest
pulse sensor.
5. Locate the indicated wires (G) inside of the housing
(A). Pull the end of the wires out of the housing
and connect it to the wires (D) on the receiver (E).
Make sure that the connectors snap together.
6. Gently feed the wires into the Upright (2) and insert
the housing (A) into the Upright.
Be careful to
avoid pinching the wires.
7. Reattach the cover (C) and the housing (A) to the
Water Bottle Holder (91) with the two screws (B).
Note: The wires included with the chest pulse sen-
sor are not needed and may be discarded.
2
C
A
91
E
D
F
B
G
D
E
Connector
Small
Cylinder