Filter
Top Products
10
14. Plug the Power Cord (96) into the Power Socket (140)
at the rear of the elliptical exerciser.
15. Make sure that all parts of the elliptical exerciser are properly tightened. Note: Some hardware may be
left over after assembly is completed. To protect the floor or carpet, place a mat under the elliptical exerciser.
The elliptical exerciser is now fully assembled. If you have purchased the optional chest pulse sen-
sor (see page 21), follow the instructions on page 21 and install the receiver included with the chest
pulse sensor.
96
140
13
13.
Attach the Left Console Cover (109) to the Console (5)
with three M4 x 16mm Screws (66). Attach the Right
Console Cover (110) in the same way.
See assembly step 11. Tighten the eight M6 x 16mm
Tapered Button Screws (107).
5
66
66
109
110
14
12. See step 13. Remove the six M4 x 16mm Screws (66)
and the Left and Right Console Covers (109, 110) from
t
he Console (5).
A
ttach the CD Holder (114) to the Console (5) with
two M4 x 12mm Screws (84) as shown.
While another person holds the Console (5) in the
position shown, connect the wire harness on the
Console to the Upper Wire Harness (86). Insert the
excess wire harness down into the Upright (2).
Attach the Console (5) to the Upright (2) with four M4
x 12mm Screws (84).
Be careful to avoid pinching
the wire harnesses.
84
86
Wire
Harness
2
5
114
12
84