Filter
Top Products
page 19
8. The flashing segment indicates your current position on the course. Use
the black directional arrows on the left keypad to change the position of the
flashing segment and to design specific portions of the course:
FWD press to move the flashing segment from left to right
BK press to move flashing segment from right to left
UP press to increase incline
DN press to decrease incline
9. Change the segment to reflect the desired incline or decline. The length of
the course may also be increased or decreased using the FWD or
BK arrows as previously described. When modification is complete,
move to the final segment of the programmed course.
CAUTION: If CANCEL is pressed during modification, all course
segments following the flashing course segment will be erased. Use
CANCEL to eliminate any unwanted course segments prior to re-
programming. This feature may only be used in Course mode and
only affects the course displayed.
10. If your completed course design is shorter than either the 20 segments pre-
programmed at the factory or an existing course, you may cancel all
remaining segments by pressing CANCEL. Then, press ENTER to save
your custom course design in the treadmill's memory.
Note: If CANCEL is pressed in error, press RESET to restore your course
design. Only ENTER stores data in the treadmill's memory.