Filter
Top Products
Owner’s Manual: EFX Features 10
Converting Handlebar Positions
The EFX5.35 handlebars can be locked in either a stationary
(Lower Body) or moving arm (Total Body) position
depending on your exercise preference. Refer to Diagram 5.
CAUTION: Never attempt to change the handlebar
connection when the EFX5.35 is in use.
Diagram 5: Converting the handlebars
The following steps explain how to convert the handlebars
from a Lower Body to a Total Body position or vice versa.
1. Hold the link arm securely with one hand as you press the
button on the quick release pin with your thumb. Pull the
quick release pin out of its receiver.
2. Rotate the link arm 90° so the quick release pin is aligned
with the other receiver. For example, the locking receiver
for the Total Body handlebars is beneath the foot pedal. If
you wish to lock the handlebars in the Lower Body
position, the locking receiver is on the base frame just in
front of the rear cover.
CAUTION: Be aware of handlebar movement. If you
move the link arm, it also causes the handlebar to
move. Do not drop the link arm. Dropping the link arm
may chip the paint on the EFX. To avoid injury to you or
your assistants, be aware of the location of the
handlebars during the conversion process.
3. Press the button on the quick release pin and slide the
pin into the appropriate receiver.
4. Let go of the button and make sure the link arm is
securely locked into position by pushing and pulling it
firmly.
5. Perform the same steps for the opposite handlebar.
CAUTION: Make sure the quick release pin is fully
engaged in the receiver and locked in position before
using the EFX.
A
t
t
a
c
h
Q
u
i
c
k
R
e
l
e
a
s
e
P
i
n
H
e
r
e
LOWER
BODY
Receiver for Total Body is
located on the foot pedal.
Receiver for
Lower Body is
located on the
base
frame.
Rear covers
Receiver label
Receiver label