Filter
Top Products
STEP 19:
FIGURE 19
20
• Route the hook end of the GUIDE CABLE (AO) thru the CABLE GUIDE (23) then SECURELY assemble the hook end of the GUIDE
CABLE (AO) to the BASE using one 3/8 X 3-3/4” BOLT (6), one 3/8” WASHER (18)and one 3/8” LOCK NUT (19) as shown in FIGURE
19.
• Route the GUIDE CABLE (AO) around one 3-1/2” PULLEY (35) and assemble the PULLEY to the FLOATING PULLEY PLATES (AB)
using one 3/8 X 1-3/4” BOLT (11) and one 3/8” LOCK NUT (19). See FIGURE 19. (NOTE: Make sure the cable runs in the grooves of
the pulleys.)
• Screw the threaded end of the GUIDE CABLE (AO) into the end of the FLOATING PULLEY BRACKET (Z). Secure the CABLE
GUIDE (23) in place with the JAM NUT on the GUIDE CABLE. See FIGURE 19.
18
19
A
Z
23
AO
3/8 X 3-3/4” 6
11 3/8 X 1-3/4”
AB
19
35
JAM NUT