Filter
Top Products
18
STEP 10:
FIGURE 10
14
63
• Assemble two PULLEY PLATES (10) around one
3-1/2” PULLEY (37) using one 3/8 X 1-3/4” BOLT
(53) and one 3/8” LOCK NUT (63) as shown in
FIGURE 10.
• Screw the long threaded end of the WEIGHT STACK
CABLE (29) into the end of the HEAD PLATE
ASSEMBLY (23) .See FIGURE 10.
• Route the WEIGHT STACK CABLE (29) around
the pulleys in the BOOM PLATES (14 & 15) as
shown in FIGURE 10. (NOTE: Make sure the cable
runs in the grooves of the pulleys.)
• Assemble the WEIGHT STACK PIN (27) to the
HEAD PLATE ASSEMBLY (23) as shown in
FIGURE 10.
• IMPORTANT! Uncoil and straighten all
CABLES in order to remove all twist prior
to installation
29
53
10
23
37
3/8 X 1-3/4”
27
15
• Tighten the two 3/8 X 3-3/4 BOLTS (57) holding the
3-1/2” CABLE GUARD (34) and the 4-1/2” CABLE
GUARD (35). (NOTE: MAKE SURE THE GUARDS
ARE ORIENTATED CORRECTLY)