Filter
Top Products
FIGURE 1
4
STEP 1
• Securely assemble REAR UPRIGHT (16 ) to BASE (10) using two 1/2 X 3" BOLTS (42), two 1/2" WASHERS (52), and two
1/2" LOCKNUTS (49).
• Slide 227" CABLE ASSEMBLY (90) through openings in BASE (10) as shown in FIGURE 1.
• Securely assembe three 3-1/2" PULLEYS (79) into BASE (10) using three 3/8 X 2-3/4" BOLTS (38), six 3/8" FLANGE
SPACERS (66), and three 3/8" LOCKNUTS (48). (NOTE: Make sure 227" CABLE ASSEMBLY (90) is routed under
PULLEYS and BOLTS.)
• Insert four 3/4" FLANGE BEARINGS (69) into tubes on REAR UPRIGHT (16) as shown in FIGURE 1
90
66
52
48
66
10
49
16
69
3/8 X 2-3/4” 38
79
1/2 X 3” 42