STEP 6:
Insert two 1/2" FLANGE BEARINGS (40) into
the LEFT PRESS HANDLE (7) as shown
FIGURE 6
Using hammer tap one 5/16 X 2" ROLL PIN (47)
thru LEFT PRESS HANDLE (7) until it is flush
with other side of HANDLE as shown in
FIGURE 6
¯
Repeat STEP 6 for the RIGHT PRESS
ARM HANDLE (6)
FIGURE 6
FLUS? SIDE
STEP 7:
Place LEFT PRESS HANDLE (7) omo PRESS
ARM (8). Make sure that the 5/16 X 2" ROLL
PIN (47) passes into the slot located in the plate
of the PRESS ARM (8)
Once in place secure and tighten the LEFT
PRESS HANDLE (7) to PRESS ARM (8)
using one 3/8" WASHER (36) and one
3/8" LOCK NUT (34)
¯ IMPORTANT! Do not overtighten: PRESS
ARM should rotate freely
¯
Repeat STEP 7 for the RIGHT PRESS
ARM HANDLE (6)
~OTr:
Place PRESS ARM (8) upside down on floor as shown Io complete this step
FIGURE 7
0-
1 2 3 4 5
6