Filter
Top Products
FIGURE 17
17
STEP 17:
1
39 3/8 X 67mm
54
49
9
60
TIGHTEN!
26
• Slide the 13/16” SHAFT COLLARS (26) up against the GUIDE ROD SUPPORT (9) and SECURELY tighten the set screws on the
SHAFT COLLARS (26). See FIGURE 17.
• Route the threaded end of the MULTI PRESS CABLE (54) through the GUIDE ROD SUPPORT (9) and SECURELY assemble the GUIDE
ROD SUPPORT (9) to the TOWER (1) using two 3/8 X 67mm BOLTS (39), four 3/8” FLAT WASHERS (60) and two 3/8” LOW HEIGHT
LOCK NUTS (49) as shown in FIGURE 17.
24
25
• Slide one WEIGHT STACK PIN (25) over the stem on the HEAD PLATE (24) as shown in FIGURE 12.
• LOOSELY thread the end of the MULTI PRESS CABLE (54) into the end of the stem on the HEAD PLATE (24). See FIGURE 17.