Filter
Top Products
STEP 16:
FIGURE 16
16
• Insert two GUIDE RODS (21) into the TOWER (1) as shown on FIGURE 16.
• Slide two 3/4 X 2” WEIGHT STACK CUSHIONS (20) down over the GUIDE RODS (21) as shown in FIGURE 16.
• Using EXTREME CARE slide all twenty WEIGHT PLATES (22) down over the GUIDE RODS (21) on to the WEIGHT STACK CUSHIONS
(20). Make sure that the WEIGHT PLATES (22) are all facing as shown.
• Slide the HEAD PLATE ASSEMBLY (24) down over the GUIDE RODS (21) onto the weight stack as shown in FIGURE 16.
• Slide two 13/16” SHAFT COLLARS (26) and the GUIDE ROD SUPPORT (9) over the GUIDE RODS (21) as shown in FIGURE 16.
21
1
22
24
26
20
9
LUBRICATION NOTE:
When finished assembling the Weight
Stack, open the lube Pack provided
with this unit and apply a thin film of
Lubricant around the first 2 to 3
inches of each Guide Rod above the
Head Plate Assembly. After the
cables are installed, use of the ma-
chine will spread the lubricant over the
length of the Guide Rods and into the
Head Plate bushings