Filter
Top Products
11
STEP 11:
FIGURE 11
• Insert one 5-1/2” TAPPED PIVOT SHAFT (28) into the PIVOT ARM (5).
• Finish assembling the PRESS ARM ADJUST PLATE (10) to the PIVOT ARM (5) using two RH CAPS (53), two BLACK RH CAPS
(52), one 3/8 X 67mm BOLT (39), one 3/8 X 73mm BOLT (41), four 3/8” SAE WASHERS (50), four 3/8” RH WASHERS (51), one 3/8 X
3/4” FLANGE SPACER (32), one 3/8 X 1” FLANGE SPACER (33), one MULTI PRESS CABLE (54) and two 3/8” LOW HEIGHT
LOCK NUTS (49) as shown in FIGURE 11. (NOTE: Assemble the MULTI PRESS CABLE to the second set of holes.) (NOTE: When
finished assembling, SECURELY tighten all three bolts.)
3/8 X 73mm 41
54
32
50
52BLACK
33
28
51
53
39 3/8 X 67mm
10
5
49