Filter
Top Products
32
Section 5: Maintenance & Lubrication
SBD3596 & SBD35108 Snow Blowers 370-347M
12/15/15
Table of Contents
Inner Skid shoes
Figure 5-7
Inner Skid Shoes (Optional)
Refer to Figure 5-7:
Inspect Inner skid shoes for wear and replace as needed.
1. Place support blocks under Snow Blower grader
blade to hold unit off the ground high enough to
remove skid shoes (#1).
2. Lower Snow Blower onto the support blocks, place
gear selector in park or in neutral with park brake set,
shut engine off, remove switch key, and wait for PTO
to stop running before dismounting tractor.
3. On the right-hand side, remove hairpin cotter (#3),
bent pin (#4), and inner skid shoe (#1) from skid shoe
mount (#2).
4. Insert new skid shoe (#1) in skid shoe mount (#2)
until at the same height of the removed skid shoe.
37315
Inner Skid Shoe Part Number
Item Part No. Part Description
1 370-439H INNER SKID SHOE
Lower Wear Bar (Lower Flighting Removed for Clarity)
Figure 5-8
35715
5. Secure skid shoe (#1) with bent pin (#4) and hairpin
cotter (#3).
6. Repeat steps 1 to 5 for the left-hand side of the Snow
Blower.
7. See “Inner Skid Shoe (Optional)” on page 22 for
detailed adjustment instructions.
Grader Blade
Refer to Figure 5-8:
Inspect grader blade and plow bolts for wear. Rotate
blade 180
o
or replace when required. Make sure wear
bar is replaced before auger housing becomes exposed
to wear.
1. Remove hex flange lock nuts (#2), plow bolts (#1),
and lower wear bar (#3).
2. Attach new wear bar (#3) to bottom of Snow Blower
frame with existing/new plow bolts (#1) and hex
flange lock nuts (#2).
3. Tighten lock nuts to the correct torque.
Lower Wear Bar Part Numbers
Item Part No. Part Description
1 802-206C 5/8"-11 x 1 3/4" GR5 PLOW BOLT
2 803-263C 5/8-11 HEX FLANGE LOCK NUT
3 820-035C SBD3596: GRADER BLADE 1/2x6x95 1/2
3 820-072C SBD35108: GRADER BLADE 1/2x6x107 1/2
NOTE: When front edge of grader blade (#3) is worn
excessively, it can be rotated 180
o
and reused to
extend its wear life.