Filter
Top Products
9
Section 1: Assembly & Set-up
12/15/15
SBD3596 & SBD35108 Snow Blowers 370-347M
Table of Contents
Section 1: Assembly & Set-up
Tractor Requirements
Tractor horsepower and hitch category should be within
the range noted below. Tractors outside the horsepower
range must not be used.
Tractor Horsepower Rating
SBD3596 . . . . . . . . . . . . . . . . . . . . . . . . 85-135 hp
SBD35108 . . . . . . . . . . . . . . . . . . . . . . 120-180 hp
Hitch Type . . . . . . . . . . . . . . . . . . . 3-Point Cat. Il or lll
PTO Speed
SBD3596 . . . . . . . . . . . . . . . . . . . . . . . . . .540 rpm
SBD35108 . . . . . . . . . . . . . . . . . . . . . . . . . 540 rpm
SBDM35108 . . . . . . . . . . . . . . . . . . . . . . . 1000 rpm
Hydraulic Quick Disconnect Outlets
Chute Rotation . . . . . . . . . . . . . . . . . . Duplex outlet
Deflector Adjustment (Optional) . . . . . Duplex outlet
Tractor Weight . . . . . . . . . . . . . . . See warning below
!
WARNING
Ballast weights may be required to maintain steering control.
Refer to your tractor Operator’s Manual to determine proper
ballast requirements.
Torque Requirements
Refer to “Torque Values Chart” on page 40 to
determine correct torque values for common bolts. See
“Additional Torque Values” at bottom of chart for
exceptions to standard torque values.
Uncrating the Snow Blower
Refer to Figure 1-1:
1. Remove discharge chute from shipping crate floor
before lifting Snow Blower from the crate.
2. Lift Snow Blower from shipping crate using lifting
holes at both ends of unit.
3. Adjust park stand to support Snow Blower level with
the floor. See “Park Stand” on page 20 for detailed
adjustment instructions.
4. Lower Snow Blower onto its skid shoes and park
stand.
5. Discard shipping crate.
Lift Points
Figure 1-1
35711
Lifting Holes
SBL3596 & SBL35108
Lifting Holes
SBL3596 Only
Lifting Holes
SBL3596 & SBL35108
Lifting Holes
SBL3596 Only
Remove chute assembly from
shipping crate before removing
Snow Blower from crate.