Filter
Top Products
20
Section 3: Adjustments
SBD3596 & SBD35108 Snow Blowers 370-347M
12/15/15
Table of Contents
Park Stand Adjustment
Figure 3-1
Park Stand
Refer to Figure 3-1:
Adjust Stand to Unhook
1. Park on a level solid surface and lower Snow Blower
to ground level or onto support blocks.
2. Raise Snow Blower off the ground or support blocks
approximately 1 1/2".
3. Engage tractor park brake, shut tractor engine off,
and remove switch key. Stay on tractor until PTO has
come to a complete stop.
4. Remove wire retaining pin (#2) and lower park
stand (#1) down.
5. Reinsert wire retaining pin in hole “A”, “B”, or “C” that
sets the stand at the correct height for unhooking.
6. Secure wire retaining pin (#2) in place by making
sure wire retainer is caught over end of pin.
Adjust Stand After Hook-up
1. Raise Snow Blower off the ground or support blocks
approximately 1 1/2".
2. Engage tractor park brake, shut tractor engine off,
and remove switch key.
3. Remove wire retaining pin (#2) and raise park
stand (#1) up to hole “E”.
4. Reinsert wire retaining pin (#2) in hole “E” by making
sure wire retainer is caught over end of pin.
35744
IMPORTANT: Snow Blower must be properly
hooked to a tractor before raising park stand up.
Deflector, Manual Adjustment
Figure 3-2
Deflector Adjustment
The end of the deflector can be angled up or down to
deflect blown snow up close or far away. This is
accomplished in one of two ways depending upon which
option was purchased.
Manual Adjustment (Standard)
Refer to Figure 3-2:
1. Stop tractor, place gearshift in park, lower Snow
Blower to ground, shut tractor engine off and remove
switch key. Stay on tractor until PTO has come to a
complete stop.
2. Pull hair pin cotter (#4) and pin (#3).
3. Readjust angle of deflector (#2) to suit by realigning
one of 4 holes “A” in bar (#1) with hole in
deflector (#2).
4. Reinsert pin (#3) & secure with hairpin cotter (#4).
5. Resume snow blowing once new deflector angle is
set.
Hydraulic Cylinder Adjustment (Optional)
1. Stop tractor and place gearshift in park before
adjusting deflector.
2. Push on hydraulic control lever to adjust deflector up
and pull on hydraulic control lever to adjust deflector
down.
3. Resume snow blowing once new deflector angle is
set.
35745
Section 3: Adjustments