Support User Manuals

Invacare RPA600-1E Fitness Equipment User Manual

Open as PDF

of 40

SECTION 2—ASSEMBLY

Part No 1078988 13 Electric Portable Patient Lift - RPA600-1E

Installing the Shifter Handle

NOTE:Forthispr ocedur e,referto

FIGURE 2.3.

1. Line‐uptheshifterhandlethreadswith

threadedopeninginthebase.

2. Turntheshifterhandleclockwiseand

securelytightenintothebase.

FIGURE 2.3 Installing the Shifter Handle

Attaching the Battery Charger Mounting Bracket to the

Wall

NOTE:Forthispr ocedur e,refertoFIGURE 2.4.

1. Placethe batterychargermountingbracketonthe wallatthedesiredposition.

2. W ithapencil,markthemiddleholeposition.

3. Measuredown 6½inchesfromthepencilmarkanddrillonemountinghole.

4. Installthebottommountingscrewuntilthereisanapproximate1/8‐inchgapbetw eenthe

screwheadandthewall.

5. Putthebatterychargermou ntingbracketontothebottommountingscrew.

6. Drilltheothertwomountingholes.

7. Screwthemountingscrewsthrough thebatterychargermountingbracketandintoth e

w all.Tightensecurely.

CAUTION

Make sure there is an audible click when mounting battery on the battery charger to

confirm proper mounting. Otherwise, injury or damage may occur.

8. Putthebatterychargerinplace onthemountingbracket.

9. Plugth ebatterychargerintoanelectricaloutlet.

NOTE:AnLEDwill illuminatewhenpowerisappliedto batterychar ger.

FIGURE 2.4 Attaching the Battery Charger Mounting Bracket to the Wall

Shifter Handle

Threads

Opening in Base

Mounting Bracket

Mounting

Screws

Bottom Mounting Screw

previous next