Filter
Top Products
iI _ iii
i!l
i i i
i i
in
COMMONPRODUCTQUESTIONS
ARETHESOUNDSMY TREADMILLMAKESNORMAL?
All treadmills makea certain type of thumping noise flue to the belt rifling over the milers,especiallynew
treadmills. Thisnoise wit diminish over time, although may not totally go away.Overtime, the belt will
stretch, causing the belt to ride smootherover the rollers.
WHYIS THETREADMILLI PURCHASEDLOUDERTHANTHEONEATTHESTORE?
All fitness proinicts seemquieter in a large store showroombecausethereis generallymorebackgrounfl noise
than in yourhome.Also,there will be lessreverberationon a carpeted concretefloor than on a woodoverlay
floor.Sometimesa heavyrubber mat will help reflucereverberationthrough the floor.If a fitness profluct is
placed closeto a wall, there will be morereflected noise.
WHENSHOULDI BEWORRIEDABOUTA NOISE?
As long as the soundsyour treadmill makesare no Iotiner than a normal conversationaltone of voice, it is
consiflerefl normalnoise.
TROUBLESHOOTING-TREADMILL
Yourtreadmill is flesignefl to be reliable anfl easyto use.However,if you experiencea problem, please referencethe
troubleshootingguifle fistefl below.
PROBLEM:If you have attempted to
move the treadmill from the box and
the machine has sprung open and
cannot be assembled.
$_]_: Theair shockshavebeenengageflprematurely. Tocorrectthis, tilt the machine on its nose bylifting
the fleck (light end) upwards.Folfl flown the fleck so that it is horizontal. Youmay nowproceefl with the assembly.
PROBLEM: Theconsolefloesnot light up anfl/or the belt floes not move.
SOLUTION: Verifythe following:
DOESTHEREDLIGHTONTHEON/OFFSWITCHLIGHTUP?
IF YES:
• Doublecheck that all connectionsaresecure,especially theconsolecable. Unpluganfl reconnectthe console
cable to verify.
• Makesure the consolecable is not pinched or damagedin any way.
• Turnthe poweroff, unping the power cable and wait 60 seconds.Removemotorcover. Waituntil aft red LED
lights havegoneoff on themotorcontrol boardbeforeproceeding.Next,verifythat noneof the wiresconnected
to the lowerboard are looseor disconnected.
IF NO:
Verifythat the outlet the machineis pluggefl into is functional Doublecheck that the breakerhas not tripped,
it is on a dedicated 20-amp circuit, it is not on a GFCI-equippedoutlet, and it is not pluggefl into a power
strip/surge protector or extensioncord.
Thepowercordis not pinched or damagedand is properlyphinged into the outlet ANDthe machine.
Thepowerswitch is turned to the ONposition.