Filter
Top Products
The control panel displays the test results until you press START/ENTER.
An erratic or low count can indicate a problem with the speed pickup or the
target decal on the flywheel. Inspect the flywheel decal for nicks, dirt,
scratches, etc. and replace if any defects are found. If the speed pickup is
loose, adjust it to within 1/4" of the flywheel and tighten securely.
C9: INCLINE SENSOR
This test allows you to elevate the treadmill up and down in any increment to
evaluate the elevation position sensor. The test displays the % grade closest to
the present position in the left window, and the actual elevation encoder count
in the center window. Each % grade is equivalent to 88 counts of the encoder.
Also, this test can be used to test the elevation zero switch, which activates as
the treadmill passes through 0% grade, causing the center encoder count to
go negative.
In this test window, the treadmill can be calibrated by holding the v key and the
+ key simultaneously.
C10: TOTAL MILEAGE
This test displays the actual accumulated total mileage, to date, in miles. The
control panel displays the test results until you press START/ENTER.
C11: TOTAL HOURS
This test displays the actual accumulated total time, to date, in hours.The
control panel displays the test results until you press START/ENTER.
C12: ERROR LOG
This test displays the last five error codes the treadmill has recorded. The
information can be reset by pressing + or –. The control panel displays the test
results until you press START/ENTER.
NOTE: Pressing the SCAN/SAVE key in C12 will clear any active maintenance
prompts.
C13: NUMBER OF STARTS
This test logs the number of machine start-ups. The control panel displays the
test results until you press START/ENTER.
Cybex 710T Treadmill Owner’s Manual
Page 7-17
Control During Operation . . 3-4
Data Readouts. . . . . . . . . . . 3-5
Selecting Programs
& Options . . . . . . . . . . . . . 3-6
Displaying Heart Rate . . . . . 3-6
Use of Programs . . . . . . . . . 3-7
Manual Mode . . . . . . . . . . . 3-8
P1 - Fitness Test Program. . 3-8
P2 - Weight Loss Program 3-10
P3 - Cardiovascular Program 3-12
P4 - Speed Challenge
Program . . . . . . . . . . . . . 3-14
P5 - Express Program. . . . 3-16
P6 - Hill Interval Program . 3-17
P7 - Speed Interval
Program . . . . . . . . . . . . . 3-18
P8 - Pike’s Peak Program . 3-19
P9 - River Run Program . . 3-20
P10 - 5 Kilometer Program 3-21
P11 - Demonstration
Program . . . . . . . . . . . . . 3-22
P101-P110 - Saved
Program . . . . . . . . . . . . . 3-22
Workout Tips. . . . . . . . . . . 3-24
4
Preventive Maintenance
Regular Maintenance
Activities. . . . . . . . . . . . . . 4-1
Cleaning Your Treadmill. . . . 4-1
Running Belt Maintenance . 4-2
Other Preventive
Maintenance . . . . . . . . . . . 4-6
Service Schedule . . . . . . . . . 4-7
Log Sheet. . . . . . . . . . . . . . . 4-8
5 Setup & Assembly
Quick Setup . . . . . . . . . . . . 5-1
Choosing & Preparing a Site 5-1
Electrical Power
Requirements. . . . . . . . . . 5-3
Unpacking. . . . . . . . . . . . . . 5-3
Assembling the Treadmill. . . 5-4
Testing the 710T Operation. 5-9
Setting Operation Options. 5-10
6 Customer Service
Contacting Service . . . . . . . 6-1
Serial Number & Voltage . . . 6-1
Warranty . . . . . . . . . . . . . . . 6-1
Return Material Authorization . .
(RMA) . . . . . . . . . . . . . . . . 6-4
Damaged Parts . . . . . . . . . . 6-4
Ordering Parts. . . . . . . . . . . 6-5
7 Service
Service Instruction . . . . . . . . 7-1
Motor Brushes. . . . . . . . . . . 7-1
Motor Current & Voltage . . . 7-4
Running Belt & Deck . . . . . . 7-7
Drive Belt. . . . . . . . . . . . . . . 7-9
Front Roller . . . . . . . . . . . . . 7-9
Rear Roller . . . . . . . . . . . . 7-10|
Error Codes. . . . . . . . . . . . 7-11
Diagnostic Tests . . . . . . . . 7-13
Parts List . . . . . . . . . . . . . . 7-20
Exploded View . . . . . . . . . . 7-23
710T Schematic . . . . . . . . . 7-24