Filter
Top Products
same incline, speed and time where you left off. If no key has been pressed during the five
minute pause,workout data will be cleared, the display will change to Dormant Mode.
Press the STOP key a second time to begin a workout review. The totals reached during your
workout session will cycle and the five minute pause will end. After the workout review is
finished the treadmill will automatically change to Dormant Mode.
Press the STOP key a third time to interrupt workout data from cycling and to change the
display to Dormant Mode.
NOTE: A set-up feature, (see Diagnostic Test C17 in the Service chapter), allows you to
reduce the pause time to ten seconds.
The function of the immobilization method: The purpose of immobilizing the treadmill is to
prevent unauthorized use. This can be accomplished by removing the power cord from the
outlet and from the treadmill.
The emergency dismount: Should you experience pain, feel faint, or need to stop your
treadmill in an emergency situation, you should follow these steps:
1. Grip handrails for support.
2. Step onto the side rails.
3. Press the STOP button two times.
The function of the emergency stop: The red STOP button functions as the emergency
stop. In an emergency situation, press the STOP button once and the treadmill will come to a
stop. If you are ending your workout session, press STOP a second time, so that the next
user will not resume at the last user’s speed and elevation.
Control During Operation
Every key on the display is usable during operation. Any key may be pressed at any time to
make adjustments in speed, elevation, level, or data readouts.
Changing Speed — Press the - + keys to change the speed in increments of 0.1 mph or 0.10
kph. Minimum to maximum speed is from 1.0 - 10 mph (1.6 - 16 kph).
Changing Incline — Press the v
^
arrows to change the elevation in increments of 1%.
Maximum elevation is 15%. (Elevation is defined as the ratio of rise over run of the treadmill
deck.)
Changing Level — During a programmed workout, press the START/ENTER key to display
the current program and level status. Then press v
^
arrows to change the level. The level will
change immediately and will continue to accumulate performance data without interruption. For
information on determining which level is right for you, see P1 — Fitness Test in this chapter.
Cybex 710T Treadmill Owner’s Manual
Page 3-4