Filter
Top Products
turned to the on (I) position and not in use. The control panel will light up and continuously
scroll program information when the treadmill is Dormant Mode.
Activating the Treadmill — Follow the steps below:
1. Plug the treadmill power cord into a power outlet from a grounded, dedicated circuit, and
one of the following: 115 VAC, 60 Hz and 20 amps, or 230 VAC, 50 Hz, and 15 amps, or
208/220 VAC, 60 Hz and 15 amps.
2. Locate the on/off (I/O) power switch on the front end of the treadmill (next to the power
cord. Toggle it to the on (I) position to supply power to the internal treadmill components
and illuminate the display panel.
3. Mount the treadmill from the rear and place your feet on the two 6” (15 cm) wide side rails
located on each side of the running belt.
! CAUTION: Always place your feet on the two 6” (15 cm) wide side rails when
starting the treadmill.
4. Press START/ENTER to enter the Select Mode.
5. Upon entering the Select Mode, the display lights to prompt the user to select the
appropriate keys. First, the display scrolls “MAXIMUM WORKOUT TIME 55 Min”. Next,
the display shows “SELECT MODE: MANUAL - PROGRAM +,” then “MAN- PRG+.”
After five seconds, if no key has been pressed, the treadmill will return to the Dormant
Mode.
6. Press the - key to select Manual Mode or the + key to select Program Mode.
7. The display shows “SET WEIGHT - or +,” then “- + 160 LB” (73 KG).
Use the - + keys to adjust the weight number displayed to reach your current weight, then
press the START/ENTER key to accept your new weight reading. The 710T accepts
weights from 40 to 400 lbs. (18 to 181 kg). After five seconds, if no key has been pressed,
the treadmill will return to the Dormant Mode. The treadmill uses your weight, speed, and
% grade to determine how many calories you burn during a workout.
NOTE: For an accurate calorie count, you must correctly set your weight (including
clothing).
8. The display shows “SELECT PROGRAM,” then “Pr1- +” and “FITNESS TEST.” Then it
shows a profile of the program followed by “PRESS ENTER TO SELECT, - + TO
CHANGE.” The display shows the same cycle of information for each consecutive
program until it is interrupted. You may interrupt this cycle at any time by pressing the - +
keys to scroll to the program of your choice.
If you select Pr1-Pr5, the display shows “SELECT LEVEL,” then “Lev 1 - +.”
If you selected Pr7, the display shows “SET MAX SPEED - +,” then “SPEED - +.”
Cybex 710T Treadmill Owner’s Manual
Page 3-2