Filter
Top Products
Cybex 445T Treadmill Owner’s Manual
Setup
and
Assembly
Page 5-5
! CAUTION: A minimum of two people are required to lift, move and assemble this
treadmill. Always use proper lifting methods when moving heavy items.
4. Lift and move the treadmill.
A. At least two people should lift and move the treadmill to a level location where you
intend to leave it. Use proper lifting methods.
5. Verify the model and voltage.
A. Verify that you have the correct model and voltage by looking at the serial number
label located at the rear of the unit..
6. Install the upright assembly.
A. Locate the upright assembly (#3) and six bolts, 3/8-16 x .625” (#15).
NOTE: Do not pinch or
damage display cable
when installing upright
assembly.
B. Carefully place the upright
assembly (#3) on the base
assembly (#1) as shown. See
Figure 3.
C. Plug the display cable,
located at the bottom of the
upright assembly (#3) into
the base assembly (#1). See
Figure 3.
D. Carefully lift the upright
assembly (#3) into the proper
location. See Figure 4.
E. Using a 9/16” socket wrench,
secure the upright assembly
(#3) to the base assembly (#1)
with six bolts, 3/8-16 x .625”
(#15). See Figure 4.
Figure 3
Figure 4
#3
Display
Cable
#1
#1
#3
#15
#15
#15