Filter
Top Products
5 - Setup and Assembly
Warnings/Cautions
All warnings and cautions listed in this chapter are as follows:
! WARNING: Use extreme caution when assembling the treadmill. Failure to do so could
result in injury.
! WARNING: During this procedure STAY OFF THE RUNNING BELT! Stand with your
feet on the two steps.
! CAUTION: A minimum of two people are required to lift, move and assemble this
treadmill. Always use proper lifting methods when moving heavy items.
Choosing and Preparing a Site
Before assembling the treadmill you must select a suitable site and have the proper
electrical outlet power available for optimum operation and safety. See the Electrical Power
Requirements section (located on the next page) for direction in locating your treadmill’s
voltage requirements.
The area you select for the treadmill should be well lit and well ventilated. Locate the treadmill
on a structurally sound and level surface (do not place in recessed areas or on plush carpet) a
few feet away from walls and other equipment. Each side of the treadmill should have a 19.7”
(0.5 m) minimum space. Behind the treadmill should be 39” (1.0 m) minimum of space. Allow
enough clearance for safe access and passage during use of the machine. If the treadmill is
to be located above the first floor, place it near or above major support beams. If the area has
a heavy, plush carpet, the airflow around the base of the machine may be restricted or the
carpeting may interfere with the moving parts. To protect the carpeting and the machinery,
place a 3/4” (1.9 cm) thick wood base under the treadmill.
Do not install the treadmill in an area of high humidity, such as in the vicinity of a steam room,
sauna, indoor pool, or outdoors. Exposure to extensive water vapor, chlorine, and/or bromine
could adversely affect the electronics as well as other parts of the machine.
Cybex 445T Treadmill Owner’s Manual
Setup
and
Assembly
Page 5-1