Filter
Top Products
Updated 23/05/07RAOM0507 Apollo Bicycle Company Pty. Ltd. ABN: 60 001 914 469
42
Adjustment
As covered previously in Part 3, to accommodate the individual rider the seat can be
adjusted in angle, height and distance from the handlebars. Generally, the saddle is most
comfortable when the top of the seat is angled almost parallel to the ground, or the front
is slightly raised. The most comfortable reach to the handlebars can be identified by
sliding the saddle forward or back along the mounting rails until the rider’s preferred
distance is located. Once identified, the saddle clamping mechanism needs to be
tightened as firmly as possible.
When attaching the seat post to the seat, position the seat post into the clamp under the
saddle. Place it in the frame without tightening, and adjust until the desired angle and
position on the post are found. Fasten the clamping mechanism. Adjust the height to the
required level and tighten the binder bolt. Note: The seat post must not extend beyond
the minimum insertion/max. height mark.
Bicycles are most commonly fitted with two types of seat clamps. The majority use a
steel clamp with hexagonal nuts on either side to tightened. The second type, a micro-
adjustable clamp, uses a single, vertically mounted Allen head fixing bolt which is tighten.
A quick release mechanism may also be used. The operation of a Quick Release seat
post mechanism is the same as for Quick Release hubs (Refer to Page 31).
To test the tension of the binder bolt, hold the seat and try to force it sideways. If the
saddle moves you need to further tighten the binder bolt.
WARNING:
After making any changes to the seat’s position check that the saddle
adjustment mechanism is properly tightened. It is also recommended this
be done prior to every ride. A loose saddle clamp or seat post binder can
allow the saddle to move, which may damage the seat post, or cause you to
lose control when riding and fall. Seek assistance from your dealer to ensure
you know how to clamp your seat post correctly, whatever type of mechanism
is fitted to your bicycle.
CAUTION:
If your bicycle is fitted with a suspension type seat post check that this is intact
and functioning properly.