Filter
Top Products
Updated 23/05/07 RAOM0507 Apollo Bicycle Company Pty. Ltd. ABN: 60 001 914 469
13
4. Steering
- Check that the handlebar and stem enable correct steering
and are properly adjusted and tightened
- Check that the setting of the handlebars is correct in relation to the forks
and the direction of travel
- Check the head set locking mechanism is appropriately fixed and fastened
- If handlebar extensions are fitted check they are positioned
and secured correctly
- Ensure the minimum insertion mark cannot be seen on the handlebar stem
- Ensure the ends of the handlebars and bar ends are covered or capped.
5. Chain
- Check the chain is lubricated, clean and runs freely
- In wet or dusty conditions service the chain more frequently
6. Bearings
- Check headset, wheel bearings, pedal bearings and bottom
bracket bearings
- Check all bearings are oiled, run smoothly and show no signs of excess
movement, grinding or rattling
7. Cranks and Pedals
- Check cranks are securely fastened to the axle and are straight
- Check pedals are properly and firmly attached to the crank
8. Derailleurs
- Check the front and rear mechanisms are operating appropriately
- Check control levers are securely anchored
- Check derailleurs, control cables and shift levers are sufficiently lubricated
- If the gear components come with a separate, specific manual, refer to this
for further information
9. Frame and fork
- Check that the frame and fork are straight and intact.
- Replace if either is bent or broken.
10. Suspension (if applicable)
- Check that components operate smoothly with no binding. Keep clean
of grit, and lubricate top of outer leg seal.
- Check that all components of the fork & rear suspension
are properly tightened
- Check the rear suspension components for excessive wear or side play
- If the suspension components come with a separate, specific manual, refer
to this for more in depth information