USING THE CONTROL PANEL
2-25
USING THE
CONTROL PANEL
USING THE TEST/PRINT MENU
To access the Test/Print menu, press the [ ] key to enter Menu mode. Press
the [5] key or the [6] key until “Test/Print” diaplays.
The Test/Print menu contains the following selections:
❐
System Reset
❐
Error Log
❐
PCL Font List
❐
PS Font List
❐
System Config
Note: This PS font list menu displays only when the PostScript
option is
installed.
System Reset
From the Test/Print menu, press the [ ] key and press the [5] key or the
[6] key until “System Reset” displays on the Control Panel.
When you press the [ ] key while “System Reset” displays on the Control
Panel, the printer resets to the settings you saved most recently. The system
resets and goes through initialization sequence, including resetting DRAM memory.
Therefore, all downloaded fonts are lost.
PCL Font List
From the Host Interface menu, press the [ ] key and press the [5] key or
the [6] key until “PCL Font List” displays on the Control Panel.
When you press the [ ] key while “PCL Font List” displays on the Control
Panel, a page prints listing the resident PCL fonts, and permanently downloaded
fonts.
