USING THE CONTROL PANEL
2-15
USING THE
CONTROL PANEL
Toner Saving Selection
You can use this selection when you print draft copies of documents. When you
enable Toner Saving, the printer uses less than the normal amount of toner,
which makes black areas print as gray but does not affect readability. The options
are as follows:
❐
On - enables Toner Saving. The printer uses approximately one half of the
normal amount of toner.
❐
Off - disables Toner Saving.
The default value is Off.
Time Out Selection
You use this selection to specify how long the printer waits for more print data
before terminating a job when it receives no end of job code.
The options are as follows:
❐
15 seconds
❐
180 seconds
❐
30 seconds
❐
300 seconds
❐
60 seconds
The default setting is 30 seconds.
Energy Saver Selection
You use this selection to specify the length of inactive time after which the
printer switches to Energy Saver mode. When the printer is in Energy Saver
mode and a job is received, the printer takes about one minute to warm up and
print the job. Energy Saver mode meets EPA Energy Star standards.
