USING THE CONTROL PANEL
2-8
USING THE JOB CONTROL MENU
To access the Job Control menu, press the [ ] key to enter Menu mode. Press
the [5] key or the [6] key until “Job Control Menu” displays. The Job Control
menu contains the following submenus:
❐
Paper Input
❐
Paper Output
❐
System
❐
PCL5 Menu
❐
Menu Reset
Paper Input Submenu
From the Job Control menu, press the [ ] key and press the [5] key or the
[6] key until “Paper Input” displays on the Control Panel. You use this submenu
to specify the input paper source.
The Paper Input submenu contains the following selections:
❐
Tray Priority
❐
Envelope Size
❐
By-pass Size
❐
Tray Size(
*
)
Tray Priority Selection
You use this selection to specify the default input tray you want the printer to
use. The options are as follows:
❐
Tray 1
❐
LCT
❐
Tray 2
❐
Envelope Feeder
❐
Tray 3
❐
By-pass Tray
❐
Tray 4
The Tray 3 and Tray 4 options display when the optional Paper Bank is installed.
The LCT option displays when the optional Large Capacity Tray (LCT) is installed.
The Envelope Feeder option displays when the optional Envelope Feeder is
installed. The By-pass Tray option does not display when the Envelope Feeder is
installed. The Tray 1 option does not display when the optional Duplex Tray is
installed.
