Filter
Top Products
7
8. Press a 25mm Square Inner Cap (69) into the
small tube on the Press Upright (5).
Slide the Press Upright (5) over the indicated M8
x 61mm Carriage Bolts (75) in the Press Base
(3). Hand tighten two M8 Nylon Locknuts (86)
onto the Bolts. Do not tighten the Locknuts yet.
Slide the Upright Support (6) over the M10 x
63mm Carriage Bolt (76) and the M10 x 92mm
Carriage Bolt (112) in the Press Base (3). Hand
tighten an M10 Nylon Locknut (90) onto the M10
x 63mm Carriage Bolt. Do not tighten the
Locknut yet. Note: Do not thread a locknut
onto the M10 x 92mm Carriage Bolt yet.
Attach the Upright Support (6) to the Press
Upright (5) with two M8 x 63mm Carriage Bolts
(113) and two M8 Nylon Locknuts (86). Do not
tighten the Locknuts yet.
8
8
113
10
86
89
11
4
1
86
86
86
100
75
75
76
112
69
86
86
86
86
90
6
3
5
7. Slide the Butterfly Leg (11) onto the two M8 x
61mm Carriage Bolts (75) in the Butterfly Base
(1). Hand tighten two M8 Nylon Locknuts (86)
onto the Bolts. Do not tighten the Locknuts yet.
Attach the Butterfly Seat Frame (10) to the
Butterfly Upright (4) with two M8 x 66mm Bolts
(89), two M8 Washers (100), and two M8 Nylon
Locknuts (86). Do not tighten the Locknuts yet.
89
100
12
67
89
3
5
75
86
50
80
86
86
9. Press a 50mm Square Inner Cap (67) into the
Press Seat Frame (12). Attach a Bumper (50) to
the Seat Frame with an M4 x 25mm Screw (80).
Slide the Press Seat Frame (12) onto the indicat-
ed M8 x 61mm Carriage Bolts (75) in the Press
Base (3). Hand tighten two M8 Nylon Locknuts
(86) onto the Bolts. Do not tighten the Locknuts
yet.
Attach the Press Seat Frame (12) to the Press
Upright (5) with two M8 x 66mm Bolts (89), two
M8 Washers (100), and two M8 Nylon Locknuts
(86). Do not tighten the Locknuts yet.
9