Filter
Top Products
20
49. Wrap the Press Cable (72) under a 90mm Pulley
(35). Attach the Pulley and a Cable Trap (38) to
the indicated hole in the Press Upright (5) with an
M10 x 93mm Bolt (85), an M10 Washer (97) and
an M10 Nylon Locknut (90). Make sure the
Cable Trap is positioned to hold the Cable in
the groove of the Pulley.
49
38
5
35
72
85
50. Route the Press Cable (72) through the opening
in the Press Frame (17) and wrap the Cable
around a 90mm Pulley (35) in the direction
shown.
Attach the 90mm Pulley (35) and a Cable Trap
(38) to the indicated hole in the Press Frame (17)
with an M10 x 81mm Bolt (104), an M10 Washer
(97) and an M10 Nylon Locknut (90). Make sure
the Pulley is attached on the inside of the
Press Frame. Make sure the Cable Trap is
positioned to hold the Cable in the groove of
the Pulley.
50
104
97
35
90
38
17
51. Wrap the Press Cable (72) around a “V”-pulley
(34) in the direction shown. Attach the “V”-pulley
and a Long Cable Trap (37) to the small tube on
the Press Upright (5) with an M10 x 81mm Bolt
(104), an M10 Washer (97) and an M10 Nylon
Locknut (90). Note: The small tube has four
adjustment holes. The “V”-pulley must be
attached at the hole farthest from the Upright.
Make sure the Cable Trap is oriented as
shown.
52. Wrap the Press Cable (72) around a 90mm
Pulley (35) in the direction shown. Attach the
Pulley and a Cable Trap (38) at the indicated hole
in the Press Frame (17) with an M10 x 81mm Bolt
(104), an M10 Washer (97), and an M10 Nylon
Locknut (90). Make sure the Pulley is attached
on the inside of the Press Frame. Make sure
the Cable Trap is positioned to hold the Cable
in the groove of the Pulley.
51
52
35
17
90
97
38
72
97
90
104
34
37
5
104
72
90
97
72