Filter
Top Products
29
97
12
72
92
34
90
97
5
72
85
34
5
90
37
37
Slack can be removed from the Press Cable (72) by
moving the “V”-pulley (34) attached to the Press Seat
Frame (12) closer to the Press Upright (5).
Remove the M10 x 93mm Bolt (85), M10 Washer
(97), and M10 Nylon Locknut (90) from the Press
Seat Frame (12), the “V”-pulley (34), and the Long
Cable Trap (37). Move the “V”-pulley to a hole that is
closer to the Press Upright (5), one hole at a time,
until the slack is removed. Reattach the “V”-pulley
and Cable Trap to the hole with the Bolt, Washer, and
Locknut.
If there is still slack in the Press Cable (72), move the
“V”-pulley (34) attached to the small tube on the
Press Upright (5) to a hole that is closer to the
Upright.
Remove the M10 x 69mm Bolt (92), M10 Washer
(97), and M10 Nylon Locknut (90) from the Press
Upright (5), the “V”-pulley (34), and the Long Cable
Trap (37). Move the “V”-pulley to a hole that is closer
to the Press Upright, one hole at a time, until the
slack is removed. Reattach the “V”-pulley and Cable
Trap to the hole with the Bolt, Washer, and Locknut.
If a cable slips off the pulleys often, the cable may have become twisted. Remove the cable and re-install
it. If the cables need to be replaced, see ORDERING REPLACEMENT PARTS on the back cover of this manual.