Filter
Top Products
28
The threaded ends on the Rear Cable (70) and the
Press Cable (72) attached to the weight stacks can
be used to tighten the cables.
To tighten the Rear Cable (70), remove the M8 x
45mm Bolt (96) and the M8 Nylon Locknut (86) from
the “U”-bracket (33) and the Short Weight Tube (44).
Tighten the M8 Nylon Locknut (86) onto the end of
the Rear Cable (70) a few turns. Re-attach the “U”-
bracket (33) to the Short Weight Tube (44) with the
M8 x 45mm Bolt (96) and the M8 Nylon Locknut (86).
The Press Cable (72) can be tightened in the same
manner.
93
32
35
90
38
70
96
86
33
100
44
86
The Pulley Plates (32) have four sets of holes for
each 90mm Pulley (35). Slack can be removed from
the cables by moving one or both Pulleys to a set of
holes closer to the center of the Pulley Plates.
To move a 90mm Pulley (35), remove the M10 Nylon
Locknut (90) and the M10 x 48mm Bolt (93) from the
Pulley Plates (32), the Cable Trap (38), and Pulley.
Re-attach the Pulley and Cable Trap to the next set of
holes in the Pulley Plates with the Bolt and Locknut.
TROUBLESHOOTING AND MAINTENANCE
Make sure all parts are properly tightened each time the weight system is used. Replace any worn parts immedi-
ately. The weight system can be cleaned using a damp cloth and mild non-abrasive detergent. Do not use solvents.
TIGHTENING THE CABLES
Woven cable, the type of cable used on the weight system, can stretch slightly when it is first used. If there is
slack in the cables before resistance is felt, the cables should be tightened. Slack can be removed from the
cables in several different ways.
When you are tightening the cables, note that they are linked into two distinct groups. The Rear Cable (70), the
Low Cable (71), the Butterfly Cable (73), and the Ab Cable (74) are all connected to the small weight stack. All
three cables will be tightened by tightening the Rear Cable at the small weight stack, or by adjusting the
90mm Pulleys (35) in either set of Pulley Plates (32).
The Press Cable (72) is attached to the large weight stack. The Press Cable can be tightened at the large
weight stack or by moving the “V”-pulleys (34) on the Press Upright (5) and the Press Seat Frame (12).