Filter
Top Products
24
65. Press a 45mm Square Inner Cap (68) into the
indicated end of the Adjustment Tube (15).
Orient the Leg Press Plate (16) and Adjustment
Tube (15) as shown in the inset drawing. Attach
the Adjustment Tube to the Leg Press Plate (16)
with an M8 x 58mm Bolt (110), two M8 Washers
(100), and an M8 Nylon Locknut (86).
Place the Adjustment Tube (15) in the bracket on
top of the Leg Press Lever (14) and secure it with
the Adjustment Pin (40).
66. Press four 19mm Round Inner Caps (64) into the
ends of the two Pad Tubes (51).
Insert a Pad Tube (51) into the indicated hole in
the Leg Lever (13). Slide two Foam Pads (52)
onto the ends of the Pad Tube.
Insert a Pad Tube (51) into the welded tube on
the Butterfly Leg (11). Slide two Foam Pads (52)
onto the ends of the Pad Tube.
67. Attach the Curl Pad (22) to the Curl Post (21) with
two M6 x 16mm Bolts (98).
68. Make sure that all parts have been properly tightened. The use of the remaining parts will be explained in
ADJUSTMENTS, beginning on the following page.
Before using the weight system, pull each cable a few times to be sure that the cables move smoothly over
the pulleys. If one of the cables does not move smoothly, find and correct the problem. IMPORTANT: If the
cables are not properly installed, they may be damaged when heavy weight is used. See the CABLE
DIAGRAMS on pages 30 and 31 for proper cable routing. If there is any slack in the cables, you will
need to remove it by tightening the cables; see TROUBLESHOOTING AND MAINTENANCE on page
28.
65
66
67
16
16
64
64
98
64
52
51
11
13
21
22
52
110
86
14
15
68
40
100
100
15