Filter
Top Products
9
AC1
AC1
AC2
AC2
AC3
AC3
1
STEP
NOTE: During assembly, it is recommended
to ensure that all bolts are in place and
partially threaded before completely tightening
any one bolt. During assembly steps 1 thru
4, do not completely tighten any bolts until
completion of Step 4.
• Lay the center floor support (AC1) on the
ground, floor pads down. Attach left floor
support (AC2) to center floor support by
sliding four bolts (M10x70) with four flat
washers (10.2x22x2) through the holes,
and securing bolts with four more flat
washers (10.2x22x2) and four nylon nuts
(M10). Repeat for attaching right floor
support (AC3).
ORANGE BAG