Filter
Top Products
12
4
STEP
• Place the two rubber bumpers (Q05)
over the holes for the guide rods in center
floor support (AC1). With the horizontal
holes at the bottom, slide the guide rods
through the rubber bumpers and into center
floor support. Let the guide rods tilt forward.
Slide each of the 15 weight plates over
both of the guide rods on top of one another.
Place the header weight plate over both
guide rods on top of other weight plates.
Slide a travel limiter ring on the left guide
rod, tightening the ring 10.5” (bottom
edge of ring) from the top.
• Make sure rubber guide rod sleeves are
in place in top holes of the center pulley
support(AB1). Lift the guide rods up until
holes in guide rods are lined up with holes
in center floor support. Slide a bolt
(M8x50) with a flat washer (8.4x15.5x1.6)
through each guide rod, securing bolt with
another flat washer and nylon nut (M8).
Tighten all hardware (horizontal hardware
first, then vertical hardware).
GREEN BAG