Vision Fitness ST700 Home Gym User Manual


 
10
2
STEP
BLUE BAG
AD2
AQ1
Q18
Weight Storage Post
• Place the chrome front upright (AG1)
over the protruding bolt ends on front of
left floor support (AC2), making sure num-
bers and holes are facing outward.
Secure using a flat washer (10.2x22x2),
lock washer (10.2x18.4x2.5), and an
acorn nut (M10) on each bolt end. Slide
the left adjustment handle (AD1) onto the
upright from the top, keeping the handle
on the side with the holes. Repeat this
process for the front upright assembling
AD2 to it on the right floor support (AC3).
Attach a rubber stop to the holes provided
at the top of the left and right chrome tube
using four flathead screws (M5x15).
• Take the left rear upright (AG2) and
stand it over the protruding bolts on the left
floor support (AC2) , making sure the
horizontal holes face inward of the
machine. Secure using a flat washer
(10.2x22x2), lock washer (10.2x18.4x2.5),
and an acorn nut (M10) on each bolt end.
Repeat this process for right rear upright
(AG3) on the right floor support (AC3).
Make sure the horizontal holes face the
outside. Attach two accessory hooks
(AQ1) to the left rear upright (AG2) with
four flathead screws (M5x15). Attach the
weight storage post with a lock washer
(10.2x18.4x2.5), a flat washer
(10.2x22x2), and a bolt (M10x70).
Attach the two plastic snap hooks (Q18)
to the outside of the right rear upright (AG3)
with four round head bolts (M5x15).
• Place the left stabilizer support (AG4)
over the protruding bolt ends on left side
of center floor support (AC1). Do not
secure that connection until later. Slide two
bolts (M10x70) with flat washers
(10.2x22x2) through holes in left rear
upright (AG2) and stabilizer support. Slide
another flat washer onto each bolt and
secure using an nylon nut (M10). Now,
secure the stabilizer to the protruding bolt
ends using a flat washer (10.2x22x2),
lock washer (10.2x18.4x2.5) and an
acorn nut (M10). Repeat this process for
the right stabilizer support (AG5).