Filter
Top Products
13
C
D
B
F
E
G
A
Solid Bol
t
Slotted Bolt
Front
5
STEP
Attach the solid bolt to the floating cable
anchor (AF1). Take the slotted bolt and nut
off of the opposite end. Route this end up
over pulley A, down around pulley B of floating
pulley bracket (see diagram for floating pulley
bracket orientation) up over C, down
around D of weight stack, up over front of E,
down around front of F, and up over the front
of G. Reattach the slotted bolt and nut to the
end of the cable. Thread into the other opening
of the floating cable anchor. After adjusting
both slotted bolts, tighten the nuts against the
floating cable anchor.
NOTE: All bolts for
cable attachments must have a minimum
of 0.5” of thread engagement. Failure
to do so can cause serious injury!
CABLE #1