Filter
Top Products
11
3
STEP
• Place the top left frame (AB4) on the left
side uprights (AG1 & AG2), with the
protruding bolt ends going through holes
in the left rear upright (AG2). Slide a flat
washer (10.2x22x2) and lock washer
(10.2x18.4x2.5) over each bolt end, and
secure with an acorn nut (M10). Secure
two bolts (M10x100) with a lock washer
(10.2x18.4x2.5) and a flat washer
(10.2x22x2) through holes over the top of
front chrome upright (AG1). Repeat this
process for top right frame (AB5).
• Place the top rear frame (AB2) up
against the back of the top left and right
frames (AB4 & AB5). Insert two bolts
(M10x70) with flat washers (10.2x22x2)
through the holes on both sides of top
frames, and secure the connection with
another flat washer on each bolt, and a
nylon nut (M10).
• Take the top center pulley support (AB1)
with the pulley bracket side down, place
the holes on the short end over the middle
holes in top rear frame (AB2). Secure in
place by sliding two bolts (M10x70) with
flat washers (10.2x22x2) through the
holes. Slide another flat washer onto each
bolt and tighten with a nylon nut (M10).
• Grab the top front frame (AB3) and
align the holes in the center with the holes
in top center pulley support (AB1). Slide
two bolts (M10x70) with flat washers
(10.2x22x2) through the holes, placing
another flat washer onto the bolts and
securing with a nylon nut (M10). To connect
to both left and right top frames (AB4 &
AB5), slide a bolt (M10x70) with a lock
washer (10.2x18.4x2.5) and flat washer
(10.2x22x2) through the front holes in the
connection points (See diagram for
clarification). For other hole, use a bolt
(M10x70) with a flat washer (10.2x22x2)
and connect other side of bolt using another
flat washer and a nylon nut (M10).
Tighten the two front center bolts.
• Attach the top front frame cover (B21) to
the top front frame (AB3) using two
bolts (M8x20) and two flat washers
(8.4x15.5x1.6).
PINK BAG
AB4
AB4
AB2
AB2
AB1
AB1
AB3
AB3
B21
B21
AB5
AB5