Filter
Top Products
GB
OWNER’S MANUAL
•
E4R
5
FEET
1. Secure the rear foot with two M10 bolts (D)
and washers (E) to the lower frame. At this point
tighten the bolts only with your fingers.
2. Lift the cycle on the floor and turn it right side
up.
3. Fasten the front foot with the transportation
wheels to the front frame the same way.
JOINING THE FRAMES
1. Remove the M5 screws in the front and seat
frames.
2. Connect the handgrip pulse wires with the
connectors in the front frame.
3. Join the front frame and seat frame by pushing
one tube inside the other so that the screw holes
in the tubes match together.
4. Fasten the frames with two M8 screws (F) and
washers (C). Do not damage the hand grip pulse
wires.
5. Secure the drink bottle rack in place with the
M5 screws.
6. Tighten the rear and front foot screws.
7. Push the plastic caps over the nuts.
SEAT BACK
1. Push the fastening screw (G) through the hole
in the seat frame tube and the assembly plate.
2. Place the bushing (H) on the fastening screw
and secure the plate by tightening the nut (I) on
the fastening screw.
3. Remove the fastening nuts and washers of
the seat back and attach the seat back to the
assembly plate with them.
4. Push the plastic caps over the nuts.