Filter
Top Products
PARTS INCLUDED:
11 -- HHEEXX KKEEYY
66 -- BBUUTTTTOONN HHEEAADD CCAAPP SSCCRREEWWSS
66 -- SSTTAARR WWAASSHHEERRSS ((LLOOCCKK WWAASSHHEERRSS))
11 -- OOWWNNEERRSS MMAANNUUAALL
11 -- WWAARRRRAANNTTYY CCAARRDD
11 -- HHEEAARRTT RRAATTEE TTRRAANNSSMMIITTTTEERR WWIITTHH
SSTTRRAAPP ((HHRRCC MMOODDEELLSS OONNLLYY))
ASSEMBLY
TRUE treadmills are shipped in two pieces:
the pedestal assembly (which includes the
control console) and the base.
Instructions for assembling the unit:
1. Remove the protective packaging
materials.
NNOOTTEE::
Do not lift the treadmill
by the motor when removing from carton!
2. Lay pedestal on deck as shown. (Fig. 1)
3. Raise top of pedestal into place.
4. Install three of the enclosed screws with lock
washers on each side, then tighten all six
screws. (Fig. 3)
IIMMPPOORRTTAANNTT::
Do not operate unless all six
screws are fastened securely. Be sure
screws and lock washers thread into the
holes in pedestal. Reverse procedure
whenever removing the pedestal. Remove
pedestal console only while treadmill is at
zero grade and unplugged.
EELLEECCTTRRIICCAALL RREEQQUUIIRREEMMEENNTT
:
Your TRUE treadmill requires
aa ddeeddiiccaatteedd
111100 VVAACC 1155 aammpp ggrroouunnddeedd oouuttlleett cciirrccuuiitt..
WWAARRNNIINNGG::
Do not use an extension cord or
an ungrounded outlet. The ground helps
prevent electrical damage to your treadmill and
enhances your safety by preventing shock.
This grounded outlet is critical for the HRC
system to function properly.
NNOOTTEE::
Units
produced for use outside of the U.S.A. will have
voltage indicated on the identification tag.
BELT ADJUSTMENTS
Your treadmill’s running belt has been
properly aligned at the factory. However,
when the treadmill is used on an uneven
surface, please follow these instructions:
PPRREEFFEERRRREEDD MMEETTHHOODD
Level the treadmill by placing shims 1/8” to
3/8” thick under the front wheel and rear
shock absorber on one side.
NNOOTTEE::
This
method will provide extended belt life by
keeping both rollers parallel. Adjusting the
belt tracking by using the roller bolts will
cause the belt to stretch on one side.
Assembly & Belt Adjustment
1-4
Fig. 3
Fig. 2
BASE
Fig. 1
PEDESTAL