Trixter X-Bike Bicycle User Manual


 
4
INSTALLATION & ADJUSTMENT
SETTING UP THE X-BIKE Indoor Performance Cycle
WARNING
NOTE THAT THE SAFETY INFORMATION ON PAGES 1 & 2 SHOULD BE FULLY
READ AND UNDERSTOOD PRIOR TO ASSEMBLING THE BIKE
A. Remove the bike and components from the shipping carton
1. With assistance, move the box to the desired location in a well-lit and well
- ventilated area. Ensure that the carton is standing upright and remove the strapping
material. Ensure that you allocate sufficient floor space for the safe operation of the X-Bike
after it has been assembled.
2. Pull the cardboard edge along the top of the box and carefully remove and dispose of the
staples. Remove the boxes of contents enclosed with the frame.
3. Open each box and ensure that you have the following parts necessary to assemble your X-
Bike™ Indoor Cycle:
X-Bike Indoor Cycle Frame including Seat Post and Handlebar Assembly
comprising Gripshift System and Hand Grips.
Separate Box with X-Bars Handlebar System Head Unit.
Separate box with front base leg including feet.
Separate box with rear base leg including feet.
Separate package with bottom X-Bar Cover (if this has been left off the assembly).
Separate package with Seat including Seat Slider Rail
Separate Box with the following
o Head stock adaptor
o Bag with Head stock adaptor bolts
o Quick Release for seat slider
o Bolts, Nuts and Washers for legs (4sets)
o Handlebar clamp including bolts
o Pedals x 1L & 1R
o Bar Ends x 1L & 1R
o Square rubber gator for Frame head tube
Separate package with the User’s manual