Filter
Top Products
26
Replacing the Centre Slider
1. Remove the top and side covers as directed in the covers removal section.
2. Using an 8mm Hex head, undo the bolt retaining this slider.
3. Remove the bolt taking care not to misplace the plastic washer behind the slider.
Centre Slider Damper Slider
4. Apply Loctite®222 to the bolt and fit through the new slider and reassemble. Tighten
securely.
5. Apply some grease to each sliding edge on the sides of the slider.
6. Refit the covers as directed in the cover removal section.
Replacing the Damper Slider
1. Remove the top and side covers as directed in the covers removal section.
2. Using 10mm and 13mm wrenches, undo the nut from the damper pin at the moving end
of the damper. Remove all components from damper pin noting their position for
reassembly.
3. Replace the 2 damper sliders with the new ones and reassemble in the same order as they
were disassembled. Tighten securely.
4. Apply some grease to each sliding edge on the sides of the slider.
5. Refit the covers as directed in the cover removal section.