Filter
Top Products
TO SWITCH TIME ZONES
The Watch can track two time zones (T1 and T2). Look at the
other zone by pressing START/SPLIT. Or, switch from T1 to T2
using these steps:
1. Press and hold START/SPLIT until HOLD FOR TIME 2
displays.
2. Continue to hold until the time switches and the Watch beeps.
3. Repeat steps 1 and 2 to switch back to T1. The message will
read HOLD FOR TIME 1.
You must independently set the time of day for each time zone.
TO SYNCHRONIZE TIME OF DAY WITH FITNESS SENSORS
When you first activate the GPS-3D Sensor in conjunction with
your Watch, you can expect one of the following scenarios:
If you activate the GPS-3D Sensor before setting the time of
day, the Watch will synchronize both T1 and T2 with UTC. You
will need to adjust the hour for both time zones to your local
time.
If you activate the GPS-3D Sensor after setting the time of day,
the Watch maintains the hour and date settings and
synchronizes minutes and seconds to UTC for each time zone.
21
You can return to Time of Day Mode from any other mode on the
Watch by pressing and holding MODE until the time of day
displays.
TO SET TIME OF DAY
For instructions on setting Watch functions, including Time of
Day, refer to page 13, “To set Watch functions.”
For Time of Day, you can set the following values:
NOTE: You cannot adjust seconds.When you use the Watch with
the GPS-3D Sensor, it will align with UTC.
When switching between Standard Time and Daylight
Savings Time, manually adjust the hour.
You can set the Watch slightly ahead or behind current
time. For example, if you typically arrive ten minutes
late, set the Watch ten minutes ahead. The Watch
remains ahead of time even when you synchronize it with
the GPS-3D Sensor.
Hour
Month
Minute
Date (automatically set the day of week
when you set the date)
Year
Hour format (i.e., AM/PM versus 24-hours)
20