Filter
Top Products
39
620-7992 Rev 001
Troubleshooting
(Continued)
Problem Possible Solution
Poor TV reception
•
Check the input signal cable, make sure it is in good shape and is connected snug
to the RF input.
•
Try a new channel; it may be the station is having difficulties.
•
Check for local interference.
•
Try adjusting the Sharpness in the PVS video setup.
Ghost in the picture
•
Check the input signal cable, make sure it is in good shape and is connected snug
to the RF input.
•
Try a new channel; it may be the station is having difficulties.
•
Check for local interference.
Missing TV Channels
•
Check the Channel setup of the PVS. The specific channel may not be pro-
grammed. If necessary, rerun the Auto Scan feature in Channel Setup.
•
These channels may be blocked, please unblock them (see Setting Parental Con-
trols section).
•
These channels may be set hidden. You may set it to show or select them with 0-9
number buttons (See channel Editor section).
Lost Password
•
You may use the super password (2580) to access the Parental Controls menu and
set a new password.
Center console key-
pad seems unre-
sponsive
•
Check to see that the ribbon cables are connected firmly and properly (ribbon may
be reversed).
•
Check center console PC board LED (will be green or red), if there is no light on the
center console, it is not receiving any power.
•
Unplug power supply from base of equipment, then plug it back
“No Signal” dis-
played on screen.
•
See “NO PICTURE”, You may have to rerun the setup routine for the display.
•
Check that all input values are correct for you service provider.
•
Press the ‘7’, ‘8’, and ‘9’ buttons simultaneously to change from AV input to RF in-
put.
Programme Edit
function not
available
(PAL system only)
If the Programme Edit feature becomes unavailable, follow these steps to restore function:
•
Press VOL-, CH- and number [3] at the same time to enter TV configuration mode,
(TV icon LED starts blinking).
•
Press VOL-, CH- and number [4] to enable Programme Edit feature, (new configu-
ration saved to memory).
•
Press VOL-, CH- and number [6] at the same time to exit TV configuration mode,
(TV icon LED stops blinking).
Note: After 30 seconds from last key press, the system will automatically exit TV con-
figuration mode.
Note: If your problem is not solved, turn your unit off and then on again.
Caution: Never attempt to repair a defective TV yourself.
For technical assistance call Star Trac Customer Service: 1 800 503 1221