Filter
Top Products
45
620-7921 Rev A
Step 29.
Take the 5” piece of tape from the PVS kit and
wrap the connectors so that all of the metal sur-
face is covered.
Step 30.
Using a 5” tie wrap from the PVS kit, bind the
cables from the PVS neck to one side of the
display mount. Take the tie and put it through
the hole on one of the display mount tubes.
Step 31.
Plug-in the 12-pin main I/O cable coming from
the unit base into the front display circuit board
at J4 connector.
Step 32.
Next, plug-in the heart rate cable from the neck
into the heart rate board connector on the dis-
play.
Tie Wrap